Nissan Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter #1
So I've only posted a few times on here before and you have all been very helpful so I hope you can help me with this new issue. I replace my engine with a engine from Japan and I have also replaced the wiring harness while I was at it. My new problem is I was stupid and didn't mark where all the vacuum lines go. Is there an easy diagram out there that would make this simple. I'm pretty sure I have most of them hooked up correctly, and have a few left that I have no idea where they go :-( But I would like to double check them all before I fire it up. Please help me out!
 
1 - 1 of 1 Posts
Top