Nissan Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
204 Posts
yep, dont beak the clips,
and no matter how much you try to remember where every screw came from, you will always put them back in different places, and have at least one left over in the end
 

·
Registered
Joined
·
70 Posts
Discussion Starter · #3 ·
Sazbot said:
yep, dont beak the clips,
and no matter how much you try to remember where every screw came from, you will always put them back in different places, and have at least one left over in the end
i will try not to...
but how to..i have very little in tools to work with
any ideas?
 

·
Registered
Joined
·
204 Posts
all you really need is a phillips screw driver, and a flat head scredriver.
the round plastic clips that have another round thing in the middle, just push the little round bit in, and the wedge the whole thing out. a bit hard to explain.
all the clips are replaceable, so dont worry to much
 

·
Soggy GloryHoler
Joined
·
792 Posts
most of the trim such as the pillar covers and door sills, and other stuff like that just pull off. The door panels are attached by screws on the bottom and clips on both sides, and after removing those you just pull up on the panel to get it off.
 
1 - 5 of 5 Posts
Top