[azkicker0027]

huh???

you don't need to take the speedo gear out to change the oil, there are 2 brass plugs on the tranny, one drain and one fill, just loosen the fill plug, the bigger of the 2 and fill it from there, and keep on filling until it overflows and now you have the proper level, i think you can use a 1/2" drive ratchet or breaker bar to loosen it, i use a breaker bar with a very short 1/2" drive extension, and for the drain, i think it takes a 3/8" drive, on thing though is the filling process, it's kind of a bitch, i use a special pump to fill it up or use a long funnel with a flexible tip to almost do a 90 degree turn, hope this helps out a bit.........

 

[azkicker0027]

too much fluid, would cause harder shifts, and fluid foaming. and some might actually seep out of the bleeder if you don't have the pipe on it. but when it overflows, you'd know when to stop.