Torque Converter
1 - 4 of 4 Posts
Your gonna need a transmission lift to get to the converter because you'll need to take the transmission out completely. This was way out of my league so i had to get a shop to do this for me and it was pretty expensive considering it was just labor, the shop i went to charged me $300. Eric and his buddy changed his torque converter by themselves so you might wanna ask him if you wanna do it yourself. Good luck.
Andre, did you try www.car-parts.com ? Local junk yards? AdvancedAuto Parts might sell them rebuilded. In worst case, send yours out. Shouldn't take Level 10 more then a week...
Joined
·
1,392 Posts
That site found 2...but from a 95 and 96. the 95 one costs $75 in North Carolina. 
Serge, I will have a few days when my mother will be away, but I wont have the money at that time, and Jay said the transmission will have to be removed...I wish it was easier. I'll just still try to find a used one.....or maybe ask people who did tranny swaps....hmmmm....
Serge, I will have a few days when my mother will be away, but I wont have the money at that time, and Jay said the transmission will have to be removed...I wish it was easier. I'll just still try to find a used one.
....or maybe ask people who did tranny swaps....hmmmm....1 - 4 of 4 Posts
Join the discussion
Recommended Reading
-
looking for cams and box.. help..
GA16DE 1.6L Enginegood day sirs'.. i have a ga16de with cold air setup and now i want to add cams to it but can't find one for this type of engine.. i tried at jim wolfe but no cams are available.. by the way my location is in the Philippines.. any help would be appreciated.. thank you very much..- 1
- 787
-
Problems with Pulsar 97
GA16DE 1.6L EngineThe problems started when my girlfriend was driving and the car lost power. She pulled over and the car didn't start after that. There was fuel coming into the engine but the spark was very weak. I changed the plugs and distributor cap and after that the car started, but with problems. By now...- 2
- 1K
-
high oil consumption. 1Qt per week, 800 miles.
GA16DE 1.6L Enginemy 99 sentra used to do just 1.5 mile to work for 6 years. Now it goes 75 miles one-way to work. It used a lot of engine oil. I have to add 1 qt per week. There is no leaking on the ground. the tail pipe is black. I am thinking the oil got burned. Any idea to save this engine? replace PCV...- 19
- 4K
-
1997 Sentra GXE - NOX, HC emissions high
GA16DE 1.6L EngineAll: 1997 Sentra GXE 4dr, automatic, AC, 123K miles - Bought new. - Replaced all spark plugs & wires after 4 years (28K miles) due to mis-fire in cylinder 1 - Oil/Filter changed every 3000 miles or 4 months - Air filter changed every 2 years - drive belts changed every 40K...- 11
- 6K
-
car alarm gone bad now my car wont start
GA16DE 1.6L EngineA few days ago I was installing at alarm on my car, the ignition red with white cable shorted with ground and now my car don't start. Could my ecu be fried I check all my fuses, the distributor coil sparks but the cap does not make a spark.- 5
- 930
Join now to ask and comment!