Nissan Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
79 Posts
Discussion Starter · #3 · (Edited)
I'm currently designing a cold air intake for my se-r. It'll be made out of 2.5" and 3" mandrel bent aluminum. I need someone to weld on the 2 fittings for the crankcase ventilation and the idle air tube. It shouldn't take that long, and I'd like to have it TIG welded. I also need to make 2 adapter plates for the MAF (out of aluminum as well).

Anyway, I'm still designing it so I don't know exactly when I'll need to find someone to weld it...

Aaron
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top