Nissan Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
272 Posts
Discussion Starter · #1 ·
OK I do not know how to connect the throttle sensor wires. The SR harness(after I sent it in to be swapped came back with a plug missing for the throttle position sensor) It was a brown plug that was too small to fit into the SR throttle body female plug. So my dad took the one off of the KA and spliced it in. I dont know what 3 wires we should connect or if we need to use all three wires. This might be a cause of the car stalling.

Any info would be appreciated.

Just something to get me going and figure this out.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top