Nissan Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
My truck dosen't have a tach on it. I have an aftermarket one and need to know what wire on the coil to tap into. This coil seems to have a bunch of wires going to it. Do I just need to find the red one or what? Thanks
 

· Registered
Joined
·
59 Posts
if i remember right, you should have the single coil, so it should go on the positive side of the coil(?). It should say in the instructions for it. If you have a multi-meter, theres also a plug behind your gauge cluster for the factory tach. I'm not too sure on which it is, but find the one for the tach and probe it till you find the one that changes voltage while you rev it.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top