Nissan Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
hey im a new member and im lookin at putting a vortec supercharger on my pulsar and i was wornding how much psi can a stock motor take and wat else would i need to make it work??
any help would be great thanks
 

·
Registered
Joined
·
8 Posts
What motor is in it??? Most engines can handle around 6-8psi without any problems or too much stress on the internals. Also depends on the condition of the engine.

When upgrading to forced induction a minimum of a hi flow fuel pump, injectors and aftermarket or piggyback computer is highly recommended. I would also recommend a compression test be done on the motor to make sure the piston rings and head gasket are sealing properly.
 
1 - 2 of 2 Posts
Top