Nissan Forum banner
1 - 2 of 2 Posts

Discussion Starter · #1 ·
Im looking for a new black shift boot, and i need that plastic thing that the boot goes around cause the little peices are broken off on the corners, Thanks.

I have a 98 200sx SE 5spd,

· ex-Super *********
1,704 Posts
Did you just brake the tabs off the front, and still have the metal clips at the rear? If so I had the same problem. To fix it I just drilled a hole in the console at the front of where the shift boot sits. Then I drilled a hole under the rubber on the bottom of the boot(front and center). Last I took a zip-tie and tied the boot to the console using the hole that I drilled to run it through. After that the rear of my boot snapped back into place and there is NO way a person can tell that its zip-tied.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.