Nissan Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
319 Posts
Discussion Starter #1
In my quest to save weight and clean up the engine bay, I decided to get rid of the battery tray. Because it sucks. :)

Cutting to enable separation of the vertical part:


After the vertical piece was removed:




After drilling 1/8" holes at (most of) the spotwelds:


After drilling 3/8" holes at (most of) the spotwelds:


Using the cutting wheel to partition the tray:


Taking out the pieces:





Using the same cutting wheel to remove the rusted part:


Blam!


The battery tray pieces laid out, all 1.2 pounds ( :loser: )of it:
 

·
Registered
Joined
·
319 Posts
Discussion Starter #4
slideurride said:
will you be doing a write up on a battery rellocation to the trunk?
I might if I was going to move the battery to the "trunk" ("hatch area" in my case). But I'm not moving it there...it's going in the passenger floor board.
 
1 - 5 of 5 Posts
Top