Nissan Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hey, I was wondering if anyone has swaped the stock rotors for some performance ones yet? I just ordered some Brembo's for the front and rear. I haven't looked yet to see how hard it is going to be but I was just wondering how to take off the old ones and put on the new ones. And also if there are any "tricks" along the way that might speed up the process or help me from f-ing anything else up that would be nice too.
 

·
Not Anymore.
Joined
·
5,014 Posts
you will want to read this about rotors
http://www.stoptech.com/whitepapers/warped_rotors_myth.htm
to be sure you do everything right for the initial break in...if not done properly you will really regret it.

pads make a much bigger difference in braking performance than rotors do. if you havent switched to stainless steel lines yet i would highly reccomend them (the goodrich ones as to my knowledge they are the only ones that are infact DOT approved).
 
1 - 2 of 2 Posts
Top