Nissan Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
So after inspecting my Evap system, every pipe is rusty and every hose is brittle. I just want to cap off the system and remove the sensors and solenoids. Now what solenoids will I have to jumper and which sensor harness will I have to connect a resistor to in order to not have a CEL. Right now I have PO440 and PO446. Is it true I can get away with a single 300 ohm resistor to replace the pressure sensor? Any technical help and experience will be appreciated.

Vehicle is for off road use only. :)
 
1 - 1 of 1 Posts
Top