Nissan Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
109 Posts
Discussion Starter · #3 ·
i get new pistons at .20 over. new rods, main and rod bearings, bored and honed block, micropolished and balanced crank. also the head deck was shaved off a bit. i had a wet 50 shot of nx in my ga. but really don't know what to run on this new motor after i break it in.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top