Nissan Forum banner

1 - 3 of 3 Posts

·
pay your rent!
Joined
·
601 Posts
Discussion Starter #1
ok this is going to sound really really really stupid but how do you read the timing scale on the crank pully? whats the value between the notches? i just advanced my timing and want to make sure i got it right because im not sure i did
 

·
Registered
Joined
·
31 Posts
Start from the left when you face the pulley.
It starts from -5 (negative five) from the farthest notch on the left then
5, 10, 15 etc... five increments. check the repair manual for it.
So is like this -5, 0, 5, 10, 15 etc... hope this helps.
 

·
pay your rent!
Joined
·
601 Posts
Discussion Starter #3
thanks green sentra! i thought this was the scale so i did it right! its just that now in nuetral when i rev the engine at about 4500 rpm it look like its not burning all the fuel, a little white smoke comes out. i put my hand over the exaust pipe for a few seconds and it smells like gas.
 
1 - 3 of 3 Posts
Top