Nissan Forum banner

1 - 20 of 68 Posts

·
Registered
Joined
·
321 Posts
Discussion Starter #1
Since the Nissan vs All area was closed down, and there was a topic like this, why don't we reopen it in the correct forum..........here!

If you've run you car at the strip, or have a dyno chart to show off (no matter how high or low it may be), post the numbers or a link here.

Also..........give us as full and total information as you can. Show your 60ft times, 1/8, 1/4, traps AND times...etc.

Finally.......can we make this a sticky?
 

·
Registered
Joined
·
321 Posts
Discussion Starter #2
My car (a 93 B13 SE-R) goes as follows:

Tristate Raceway, Earlville Iowa........last fall.

Mods: HS gen 5 header, timing advance (16.5 deg.), JWT clutch, ES motor mounts.

60' 2.322 (minor wheelhop)
330' 6.391
1/8 9.795
MPH 72.35
1000 12.728
1/4 15.214
MPH 90.06 (on the rev limiter in 3rd)


I have since added a HS CAI, but while my trap speed jumped to 90.84mph, I only managed a 15.393 this spring due to wheelhop out of the hole (Yoko AVS's with STIFF sidewalls do not spin smoothly).
 

·
Registered
Joined
·
225 Posts
My car is a 1991 SE-R, 85k on stock Motor, stock clutch.
Mods are HS CAI, Gen3 headers, Stromung Mid-Pipe, Stillen Muffler, and JWT S3 cams, timing is 15.

My best time so far is [email protected] 92.2mph, 2.27 60' time.

This was done at Sacarmento Raceway. Is the time right? I was actually expecting 14.7 with these mods... with a trap at 95 or so...

Well.. later that night I found that I have a REALLY bad exhaust leak,that could be part of the reason why I'm kinda slow.
 

·
Registered
Joined
·
50 Posts
b18c1
83mm Darton(3rd gen) sleeves
RLZ Custom pistons
Pauter Rods
FACTORY bearings
Precision Turbo SC61
Todd made turbo manifold, very similar to fullrace
3" SS dp
tuned factory ECU with 2 step (7500), data logging, and full throttle shift
CM 5 clutch
DSS stage 4's
Quaifee LSD
Y80 tranny with 4.40 FD
hurst short shifter
M&H slick
Bogart Drag oN wheels
BIG ass intercooler :p
2.5" I/C piping
Greddy Type R BOV
Tial 48mm w/g
and blah, blah, blah All on 24psi
 

·
265k miles and counting..
Joined
·
2,656 Posts
My stock 98 Frontier King Cab(KA24DE/5spd) ran a [email protected] in the 1/8th at Sunshine Speedway when it had only 155k miles on it.That was with a slipping clutch too.
 

·
Registered
Joined
·
70 Posts
MY TIMES

i have only ran my car twice since i got it and it was only at the 1/8 mile track. these runs are with only a intake (not CAI), timing advanced 15 deg., 2 1/4 in. exhaust and an accel super coil. i also had full interior and an audio system with one 12 in a heavy ass box. since then i have removed th stereo system some interior stuff including the entire heating system (including all the not so heavy air ducts under the dash) and i installed a cold air intake and eliminated the cat. when i get a lil more work done ill post more time

here are my times........
first run second run
r/t--------1.099--------------.840
60--------2.551--------------2.447
et--------10.942-------------10.954
mph------63.69--------------63.26

i think i could have done better with diff tires because i was on the stock 13in steelies with some mixed matched tires that had no grip whatso ever.
 

·
My Other car is a SE-R
Joined
·
447 Posts
Well in San Diego there is no 1/4 track [that I know of...]
But theres a 1/8 track and my best was 11.258 @ 63.92 mph with my bone stock 98 SE-R...
 

·
Registered
Joined
·
24 Posts
well, wince we're posint 1/8th mile times mine are as followes:

my first time at the track and with dunlop sport a2's at 25 psi i ran a 9.56 at 74.xx mph. getting a 2.3 60ft. power mods:
warm air intake, act 6 puck clutch, nology wires, pacesetter header, and a flowmaster single chambered muffer.

second time at the track, the only difference was that i was running with slicks (20x14x6) at 9psi, first time too, getting a 1.98 60ft and ran a 9.20 at 74.xx mph.

oh i have a 92 se-r, and its forsale.
 

·
P.O.S. Truckdriver
Joined
·
2,070 Posts
10.80 @ 64mph in the 1/8

mods are: wai, 2 1/4 crush bent exhaust, timing at 19 degrees, act clutch, full ES mounts. engine is a ga16de. i dont have a r/t or 60' bc they didnt give out timeslips that night. best 60' ever was a 2.4xx and best r/t was a .2xx(not like it matters).
 

·
Registered
Joined
·
15 Posts
At sturgis dragway 1/8th mile, elevation of 3200 ft., my 97 200sx se-r ran 9.046 at 77.75. The problem that i am having is my 60 ft. is only 2.09. i have been launching on a 75 shot of NX, with bfg drag radials and using it through the complete race. the car does have 137,000+ mls. on the orignal motor and clutch so i can only launch at about 3500 with out losing the clutch.
 

·
My Other car is a SE-R
Joined
·
447 Posts
Had my car dynoed today...

Max Hp: 119.7 @6500
Max Torque: 101.1 @5750

Stock 98 SE-R Atutomatic.....
 

·
Registered
Joined
·
113 Posts
Just got back from Capital Raceway in MD. My 87 Pulsar E16i w/ rebuilt engine, Nismo Euro cam and GA16i throttle body ran the following:

R/T .662
60' 2.651
330 ft 8.189
1/8 mile 12.828
1000 ft 16.868
1/4 mile 20.288 @ 66.20 mph

Not fast but still fun. The GA16i throttle body swap was worth 1/2 a second from my prior best of 20.701 @ 63.82 mph. I still need to tune the throttle body.

Next up is the Pacesetter header I just bought on Ebay for $100 plus a new Random Technology cat and a new muffler.
 

·
Registered
Joined
·
82 Posts
its the track

atomicbomberman said:
My car is a 1991 SE-R, 85k on stock Motor, stock clutch.
Mods are HS CAI, Gen3 headers, Stromung Mid-Pipe, Stillen Muffler, and JWT S3 cams, timing is 15.

My best time so far is [email protected] 92.2mph, 2.27 60' time.

This was done at Sacarmento Raceway. Is the time right? I was actually expecting 14.7 with these mods... with a trap at 95 or so...

Well.. later that night I found that I have a REALLY bad exhaust leak,that could be part of the reason why I'm kinda slow.

part of the reason i think is that your at sac raceway, which is not the best of tracks, not very well mantained and old, you should go to infinion raceway (was sears point), much nicer track plus closer to sea level.
 

·
Registered
Joined
·
1,818 Posts
1997 200SX SE-R
Level 10 Auto Trans (3200 rpm stall converter)
HotShot Turbo (T3)
Profec B Boost Controller
JWT Nitrous 50 Shot
JWT S2 Cams & Sprockets
370 Injectors
Stock MAF
GReddy Cat Back
M/T 3019 Slicks (22.0/8.0-15)
Bogart Drag Star 8in. Rims

At 9# boost in the 1/8 mile spraying off the line:
60ft - 2.1411
330 ft - 5.7515
1/8 - [email protected]

[I'm still learning how to launch]

Lew
 
1 - 20 of 68 Posts
Top