Nissan Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have just finished restoring my wiring harness (a rat ate it while in storage for 15 years) and the car runs and drives but there are 3 OBD codes showing. Code 23- idle switch, Code 31- load signal, Code 32- start signal. I need help narrowing down the source of the problems. Could Code 23- idle switch be a bad throttle position switch or is the actually an idle switch?
Could code 31- load signal be a bad load diode? Could code 32-start signal be a bad ignition switch? And lastly how do Clear the codes when it is resolved? A bit further info: slightly sluggish from idle when gas is applied quickly, little low end power. Revs out to redline easily after the initial bog down from idle. Starts very quickly and easily every time. Slight ticking from either ac compressor or valves not sure which but will be running an oil treatment and seafoam in the next few days.
 
1 - 1 of 1 Posts
Top