Nissan Forum banner

1 - 7 of 7 Posts

·
Moderator/ NPM staff
Joined
·
522 Posts
Discussion Starter #1

To those of you that are interested in the B12 chassis sentra and are desperately searching for performance modifications, check out Nissan Performance Magazine's Project B12 SR20DET

If you have any question or comments feel free to post them in NPM's project car forum here

Below is a list of modifications that have already been performed to Project B12 SR20DET.

Engine
JDM SR20DE
VLSD transmission
GTI-R turbo Manifold
T28 turbo
370cc injectors
2-1/4 mandrel intercooler piping
Mitsubishi intercooler core
with custom end tanks
Oil Catch can
300zx Pop Filter
JWT Engine mounts
Clutch specialties 6 puck
JWT ECU
Blitz super sound blow off
Front Strut Bar
SER radiator

Exhaust
3" Ultra flow Muffler
3" Mandrel bent downpipe
3" Mandrel bent exhaust system
3" Test pipe

Suspension
KYB AGX adjustable struts
Ground control coil over kit

Brakes
Front Se-R disc brakes
SMC steel braided lines

Interior
Autopower Roll bar
My Carr racing pedals
Momo Carbon Fiber shift knob
Sport coupe seats
HKS EGT
Auto power boost gauge
Auto power Tachomter
Greddy Turbo Timer
Blitz Twin solenoid boost controller
Autopower Camera mount
GT steering wheel
SMC Short Shifter

Wheels
15" milano mesh
195/50/15ZR Toyo

14" stock 200sx rims
Nitto 555R drag radials

Exterior
Xenon Body Kit
Nismo LE Front Grill W/
Sunny Super Saloon Emblem
JDM clear corners
Nissan Hardbody clear bumper lenses
Moroso Kill Switch W/
Battery relocation kit
 

·
Registered
Joined
·
163 Posts
did you have the xenon kit or the kamari kit
 

·
Proud owner of a GA16i
Joined
·
508 Posts
With that, you should also throw in some place that has B12 mounts for a SR20. If I didn't have to do a DIY mount, I'd love to drop in a SR20.

Also, you wouldn't happen to have the CAD specs on the rear brake mounting brackets, would you?
 

·
off topic VIP
Joined
·
388 Posts
Galimba1 said:
...Also, you wouldn't happen to have the CAD specs on the rear brake mounting brackets, would you?
last time i talked to charles, he said the brackets were expensive to make, and said he had no plans to get them mass-produced. its nearly impossible to get in touch with him cuz hes busy all the time.

id try to contact charles by email.
if someone could get the specs on those brakets and start making em, id buy a set.
 

·
Ex-mod/nissan guru
Joined
·
2,136 Posts
thing was that it will be costy to have those made (mass produced) and how many of us will buy some !??... not much really... and for all the time he spended on the CAD, i wouldnt pass it on like an info or such... this things worth a lot. As for the engine DIY mount, still no one makes a kit for the b12, its is always costom :)
 
1 - 7 of 7 Posts
Top