Nissan Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
70 Posts
Discussion Starter · #1 ·
i installed a Jdm mines ecu in my sentra today and when finished, i started it up and the rpm gauge didnt work. Please help.
And how hard is it to install a 5'' tach. Never done it.
Thx
Tomglenn
 

·
My ass, your face
Joined
·
6,612 Posts
tomglenn said:
i installed a Jdm mines ecu in my sentra today and when finished, i started it up and the rpm gauge didnt work. Please help.
And how hard is it to install a 5'' tach. Never done it.
Thx
Tomglenn

the jdm gauge might use a different signal for the reading....pull the cluster out and check the harness and the back of the cluster...see if the TAM is on the same location. Oh, and as far as a 5" aftermarket tach...installing it is TOO easy.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top