Nissan Forum banner
1 - 3 of 3 Posts

·
Admin and Sup Mod keeping the peace
Joined
·
8,277 Posts
What type of repair did you perform on the engine? According to the FSM, the cam shaft position sensor is built into the distributor and the distributor bolts on to the end of the camshaft. So the distributor mechanically connects to the camshaft only one way. Maybe the rotor is not sitting correctly; might be loose. Is the crankshaft front pulley in good condition?
 

·
Admin and Sup Mod keeping the peace
Joined
·
8,277 Posts
Something wasn't done correctly when setting the chain timing during the reassembly. You can be off by one tooth in one of the two chains which can cause your condition. Hopefully you had a copy of the FSM for your vehicle which describes the chain assembly timing. Here's where you can get a copy of the FSM; section EM.PDF is the one to read:

 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top