I need to remove the rear trim from my 2006 quest in order to replace a fuel door actuator.
Is anyone here familiar on how to do this removal without breaking the plastic paneling?
Here are photos of the paneling I need to remove:
Has anyone replaced the radiator clutch fan with an electric fan? If so any recommendations on which fan and thermostatic fan control? I already plan to get a beefier altenator. Just looking for ideas and suggestions.
I was wondering if anyone has put on either a curt or reese aftermarket hitch? I see curt has the 13900 and reese has the 37042. Has anyone put one of these on? If so did it go smoothly? Any drilling or modifications to be made to make it work?
I have a 97 pickup with a bad 2.4 engine and I have a chance to pickup a 1990 pickup with a rotten frame for cheap 2.4l. Will I be able to swap the engine from the 90 into the 97 without any major issues? Thanks in advance.
Sent from my SM-N950U using Tapatalk