Nissan Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
37 Posts
Discussion Starter · #1 ·
So after a tough upper and lower ball joint replacement... i decided while i'm at it to repack the bearings... welllll that was no problem but when i went to Oriely's to get my new wheel seal/hub seal/grease seal whatever you want to call it.... the new part doesn't fit.... it looks like it would fit fine but never seats down onto the hub... almost like its too shallow... anyone ever have this problem? Am I going to be buying from the stealership?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top