Joined
·
11 Posts
New Forum member
1 - 9 of 9 Posts
Joined
·
388 Posts
Right on Thomas..good to have ya over here too...
Joined
·
14 Posts
Whatz up everyone
new on this forum too..
new on this forum too..
K
kpw97
·Guest
Joined
·
0 Posts
Go figure me too
J
Jorge Ramos
·Guest
Joined
·
0 Posts
Wow Thomas you are new!?! ME TOO!
ME TOO! 
S
SERMitchell
·Guest
Joined
·
0 Posts
Yup you guessed it, I'm new too. Whats up Brad!
Joined
·
388 Posts
hahahaa....whats up buddy.... glad to see you on the darkside...
glad to see you on the darkside...1 - 9 of 9 Posts
Join the discussion
Recommended Reading
-
QG18DE Tuning Guide and MODS list
QG18 1.8L EngineQG18DE Naturally Aspirated Tuning: Keep in mind, while upgrading your QG18DE powered car with naturally aspirated parts, the power gains will not be substantial, and it will cost a significant amount to get some decent power in naturallly aspirated form. For the stock QG18DE, the best bang for...- 62
- 106K
-
chimmike · updated
-
OX Sensor B1S2 question 2002 GXE ulev
QG18 1.8L EngineHi i bought a used 2002 Sentra GXE WITH CALIFORNIA EMISSIONS. The car was getting a P0138 , on a scan tool B1S2 showed a constant .300mv the corresponding short term fuel trim says N/A. I replaced the ox sensor and now it shows on the scanner O2 ready where before it was not. Is that...- 1
- 154
-
SentraBill · updated
-
02 Nissan Sentra GXE 1.8L
QG18 1.8L EngineHey all, I need some help. While driving to the gym my car started spuddering then shut off while driving. So I coasted to the parking lot since I was about to pull in, finished pushing it into the parking spot. Engine turns but won't start. Left it there, next day though, starts right up. The...- 2
- 359
-
OmiBC · updated
-
Crank/no start after crank position sensor replacement
QG18 1.8L Engine2004 Sentra 1.8. Was stalling while driving. Got code p0335. Replaced crankshaft position sensor and now it cranks but won't start. It was such a pain getting it out, but the replacement went right in and was loose until bolted, is this normal? Currently at a loss and ready to tow it to the...- 1
- 255
-
Weber carb setup on e16i?
QG18 1.8L EngineI've got an 87 pulsar with the e16i. Came across locally an intake manifold with the carb for an 82/83 Sentra with an e15. Will this intake manifold fit my e16i head? I've done some looking but haven't really come across anything! If it'll work I'll snag up a Weber carb setup for it!- 0
- 301
Join now to ask and comment!