Nissan Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
Hello,
I am a new member here. I don't own a nissan/infiniti yet, but looking around this spring for something to catch my eye. Anyway, I am going to try to help a friend change the clutch on his '95 sentra. I haven't seen the car yet, but it sounds pretty run-of-the-mill. I have changed a clutch on my old 3000gt, and on my dad's ranger pickup, so I have a little experience. Is there anywhere detailing advice for something like this (common pitfalls, etc) or should I just find a manual to read. Also, if that's the case, any recommendations for manuals on the vehicle? thanks a lot
Jesse
 

·
Registered
Joined
·
10 Posts
Discussion Starter #4
thanks for the good luck. I did a little searching earlier, but after your prodding i've done some more. ended up with the FSM. Hopefully that will help.
Does anyone know how much this tranny weighs? the one in my mitsu was about 125lbs and I could sorta manhandle it into position. If this is under 100lbs, it would make my life easier. if not, ugh. thanks
 
1 - 4 of 4 Posts
Top