Nissan Forum banner
1 - 1 of 1 Posts

· Registered
8 Posts
I just did the same thing, my problem was when I installed the cams, I was one tooth off on the time chain, the computer will not allow the engine to start if the cam shaft and crankshaft don't match up. I move the cam shaft one tooth, engine started. Then after that you have to run the learn program on the throtle position and idle air program.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.