Nissan Forum banner
1 - 1 of 1 Posts

Discussion Starter · #1 ·
Can anyone give me tips on swapping out rod bearings? I've got the motor (54C) on a stand and was told that the easiest way is to flip the motor upside down. I have tried this, but I can not get the rod off the crank and my fingers barely fit because of the main bearing beam. Can I just remove this beam without removing anything else, or is it connected to other stuff? All opinions will be appreciated. Thanks.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.