Nissan Forum banner
1 - 13 of 13 Posts

·
Registered
Joined
·
259 Posts
Discussion Starter · #1 ·




Intercooler breathes much better now!! Visibilty is unbeleiveable too, these are real HID's.
John
 

·
Registered
Joined
·
259 Posts
Discussion Starter · #6 ·
The bumper was pretty easy. 15 minutes with a body saw and a dremel/di-grinder and you're all done. Cut it from the bottom edge to just above the license plate brackets and round out the corners and straighten the edges. Paint the bumper and air dam seperately. For best results use base coat/clear coat. Glue and screw dam to bumper, wet sand and buff if the super glassy finish is desired. Install mesh behind the openings for a clean look, and trim the foam insert so its not visible through the openings. For those of you with out intercoolers, all you will see back there is a big nasty bumper support through the newly created hole. Just something to keep in mind. Thanks for the compliments, maybe one of these days I'll put the trim piece under the grill and headlights back in ;o)

John
 
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top