Nissan Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
451 Posts
Discussion Starter #1
I put energy suspension polyurathane bushings in my lowere control arms. When taking apart the balljoint the bootl busted.I bought some at autozone. They were just a little small .040. I drve around looking for the right size no auto stores had them Im going to try nissan has anyone else had this problem?
 

·
Registered
Joined
·
451 Posts
Discussion Starter #2
I went to nissan they said I had to buy a whole new control arm, the ball joint is not sold seperately. This defeats my purpose of putting the polyurethane bushings in if I just get rubber ones again. Has anyone else heard of this
 

·
Registered
Joined
·
451 Posts
Discussion Starter #3
I found the correct size lower ball joints at Napa. Thay was almost twice as much as other stores but they fit correctly so its worth it.
 

·
Registered
Joined
·
451 Posts
Discussion Starter #5
Where they fit into the lower control arm or the control arm hole circumfrence is 1.540
 
1 - 7 of 7 Posts
Top