Nissan Forum banner
1 - 1 of 1 Posts

· 99 Problems...
339 Posts
Discussion Starter · #1 ·
I have yet to take a 16ve apart but im assuming the rods are a bit thinner than 20de/ve rods.

My question is would it be better to use the longer 16ve rods with an 89mm bore, or 20det rods with the same bore?

get custom carrillo rods in 16ve length

Since the 16ve rods are .3406in longer than DE rods I could move the pin up 7-8mm on the 89mm piston.

If you have serious technical insight please chime in. I am aware of what rod/stroke ratio is and what the theory surround it is so don't bother sharing knowledge I can google up
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.