Nissan Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
160 Posts
Discussion Starter #1
Im looking to get some more load capacity from my truck, 97 2wd 4 cyl HB.

THe stock springs are quite grampa-ish, are there any direct swap springs/perches to perk it up some? Like from a 2wd Pathfinder? And how about the torsion bars, all the same, or will some from a heavier vehicle bolt in???

Thanks in advance!
 

·
Registered
Joined
·
160 Posts
Discussion Starter #3
Aftermarket? im a junkyard dog, anything i can get there is cheap! =)
 

·
Registered
Joined
·
706 Posts
Look for the HD trucks( dualie), 4x4 trucks, and V6 powered truck they tend to have the beefier parts!
 

·
Registered
Joined
·
160 Posts
Discussion Starter #5
How would I use v6 HB springs without lifting the ass end too much?

Or an alternate method, how hard is it to get a 2wd front end up to 4wd height w/o the alignment problems or lack of downtravel? TO utilize 4wd rear springs and be able to make the front end match
 
1 - 6 of 6 Posts
Top