Nissan Forum banner
1 - 12 of 12 Posts

· Registered
Joined
·
74 Posts
Discussion Starter · #1 ·
and slightly disappointed to be honest....:S



everyone ran less than what they thought they would do and they weren't running anywhere near full whack, didn't redline it at all....was a mass group day out so it was a bit, on the rollers, run it get them off the rollers....

heres a vid as well if you want to see....mines the last one...

Mods are CAI, Hotshot header and powerflow custom exhaust...

http://www.primera-egt.com/RR/well-lane.wmv
 

· Registered
Joined
·
74 Posts
Discussion Starter · #4 · (Edited)
oh don't get me wrong....i'm not dissappointed in the figure at all...i really wanted 110...lol

No i was mostly disappointed in the rolling road guys...didn't seem to give a toss really...which sucked! The service was pretty average...didn't even have a chat about the car or anything...

Would you expect them to bounce it off the limiter when doing a power run as he was running it to 6K rpm and then shutting off the throttle and putting in neutral as they were running spinback or something....:S

Got a decat pipe and going to advance the timing to 15o in the near future and get it rolled again...then maybe think about an engine swap i reckon... :rolleyes: might go SR20VE....it's either that or turbo but i just don't think i can justify the expense on an engine thats 88K old and i'm putting it under even more strain where importing SR20VE is the same price and close to the similar power....and then mods on top... :) We'll see....
 

· Registered
Joined
·
74 Posts
Discussion Starter · #8 ·
thanks for the offer but i've either got the GA16DET or the SR20VE stuck in my head!!

It's all down to money etc now....

i'm impressed with my torque curve though i must admit...a lot better than some of the SR20 boys were putting out at the rr :rolleyes:
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top