Nissan Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
272 Posts
Discussion Starter #1
The two vacuum lines on the SR S13 ignitor chip...where do they route to?

Thanks

My engine cranks but doesnt turn over and I think that is the problem
 

·
Registered
Joined
·
76 Posts
one vacuum line goes to the egr valve to the egr controller and the other to the boost cut solenoid. do you have both of thous pieces? they are mounted on the same plate as the ignitor chip.
 

·
Registered
Joined
·
272 Posts
Discussion Starter #3
nismo200sx16 said:
one vacuum line goes to the egr valve to the egr controller and the other to the boost cut solenoid. do you have both of thous pieces? they are mounted on the same plate as the ignitor chip.
do you have a picture? I havent seen one picture of an ignitor chip anywhere on the internet, well at least the chip from the swap.

Thanks
 

·
Registered
Joined
·
76 Posts
no I don't have any pics. If you have pics I am sure I can help you out.if you look on ebay you can find pics of the chip. no vacuum lines actually go to the chip, just the wires from the harness. vacuum lines could be the problem but its more than likely wiring.
 
1 - 5 of 5 Posts
Top