Nissan Forum banner
1 - 17 of 17 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter · #1 ·
Hey all I have a 1986 D-21 with a FI 2.4L. When coming to a stop I push the clutch in and the idle drops like it wants to cut off then idles rough for a few seconds then back to normal. I have new 02 sensor coolant temp sensor thermo wax kit cleaned MAF ecu says throttle / idle switch. Went to the junk yard got a TPS and still same thing. Any help in the right direction would be greatly appreciated
 

·
Registered
Joined
·
34 Posts
Discussion Starter · #5 ·
Thanks for your reply.if you dont mind me asking what is the bpt valve and if you are facing the throttle body which side is it on.I have checked all vacuum lines numerous times.If i route the fuel pressure regulator to a manifold source what do I do with the ends that is coming out of the top of the throttle body going to the fuel pressure regulator.Again thanks for any help you offer.
 

·
Registered
Joined
·
34 Posts
Discussion Starter · #9 ·
Ok here is a list of all i have done thus far
Nissan Wires - NGK Plugs
Distributor - Cap - Rotor Button
Set Timing
Compression Test
Thermostat - Heater Core
Engine Coolant sensor - To the computer
New fuel filter
TBI cleaned
New TBI gaskets
FI filters & o-rings
Used TPS per Vehicle computer
What am I checking on the BTP
 

·
Registered
Joined
·
34 Posts
Discussion Starter · #18 ·
I want to say thanks for your time trying to help me get this truck rite. I had heard of a procedure of adjusting the TPS but I am far from a mechanic. I did notice the oblong screw holes. Should I take the TBI off to adjust the tPS or can it be done on the truck. There is only about a quarter inch adjustment either way correct.
 

·
Registered
Joined
·
34 Posts
Discussion Starter · #23 ·
I have made a little progress. I did find a rather nice vacuum leak on my bp valve hose. As far as the tps I can't seem to get it adjusted correctly. What exactly were the symptoms your truck was giving. That would be great if you could send me the supplement manual. also thanks for your reply
 

·
Registered
Joined
·
34 Posts
Discussion Starter · #27 ·
Thanks for the replies and sorry for the laps in time. I checked everything as instructed and I only got voltage on the tps plug side no voltage from the tps. Also i tried two different tps's and the truck drives with the tps unplugged am I missing something
 
1 - 17 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top