Nissan Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
61 Posts
Discussion Starter #1
i removed my aftermarket kenwood POS HU and replaced my RF factory HU.

the only wires i touched were the stereo wires and the HVAC wires (so i could remove the front bezel). i had to run the sirius antenna wire over to the outside wall to the left of the steering wall, which passes all the wires underneath the steering wheel...but i didnt disconnect anything, cut anything or mess with any other wires.

i never removed my a battery terminal before swapping the HU... could this be the problem? maybe its a simple code reset?


anyone have any idea? all help is greatly appreciated. please save me a trip to the dealer!!
 

·
Registered
Joined
·
61 Posts
Discussion Starter #2 (Edited)
NEVERMIND!!! I shouldve looked 3 posts down!!!DOH!! IT WORKED!!!!!!! THANK YOU NISSANFORUMS!! woohoo! you just saved me a trip for the god-forsaken nissan dealer! i owe the site a beer.!
 
1 - 2 of 2 Posts
Top