Nissan Forum banner
1 - 1 of 1 Posts

· Registered
20 Posts
Discussion Starter · #1 ·
I own a 1996 nissan 200sx se-r and I am planning to do some more mods to it. In searching for a unique mod that will keep my car competitive with other imports out there, I draw my attention to the clutch. On every se-r the clutch is equipped with cable actuation instead of the fluid smooth hydraulic actuation. I want to install a hydraulic clutch setup in my car. I am aware that the QG18 engine uses the same clutch and flywheel setup as the SR20. The QG however has a hydraulic clutch. What would it take to install the hydraulic setup into my se-r? Thanx.:)
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.