[Guest]

I just saw this one ebay and I was wondering if I could get this on to the back of my car and what would the process involve:

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=1857601813

 

[SentraBoy]

Don't try it....You have yo cut all the holes which are missing on an XE or get a trunk lid from an SER. They you will have to wire in the additional lights. It will take a lot of work.

 

[Black200SXSER]

We did it on a guys sentra here...It wasnt that hard...just have to mark and cut the holes..and it helps if you have the harness for themas well.then it was just soldering it in place. If you are good at doing car stuff, it is very doable...

 

[toolapcfan]

I suppose it could depend on production year, but I was comparing the trunk lids of my XE and SE-R and the only thing missing from the XE to make that additional light section fit is a few small holes for the mounting bolts to go through and a hole for the wiring harness. Should be a piece of cake. The only thing that might be tricky is swapping your trunk lock into those lights and getting it all to link up correctly, since your's is flush to the metal and those are flush to the light. The additional wiring will only be difficult because you don't have the harnesses, but wiring a harness in wouldn't be too bad. Let me know if you need help on the wiring if you decide to do it, I'd be glad to help.

 

[Guest]

eh, nevermind. Maybe I'll do it later; I think I'll spend more money under the hood before I spend it on the trunk. Thanks anyway.