Nissan Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Im doing a head gasket replacement and cant get the damn sprocket nut off! Any ideas or tricks? Thanks!
 

·
Registered
Joined
·
1,124 Posts
welll if its anything like a sr20 cam then they are on there with over 100 ft pounds BUT there should be a spot were u put a open ended wrench on just to the right of the gear itself and if so then just put huger leverage bars on each wrench and use the right size u dont wanna strip anything
 

·
Registered
Joined
·
20 Posts
J_Brock said:
Im doing a head gasket replacement and cant get the damn sprocket nut off! Any ideas or tricks? Thanks!
The Bolt is 22mm and you can hold the sprocket with socket wrench pushed through the holes.

Techno
 

·
Registered
Joined
·
5 Posts
Discussion Starter #4
Got it done, thanks guys! It took a breaker bar, and a socket wrench through the hole to get it done. Thanks again.
 
1 - 4 of 4 Posts
Top