i have been told but don't know for sure that you can use the flywheel from the R36 motor on the QR25 that it is the samd diameter, # of teeth, and bolt patterns but is lighter by a few pounds. will this actually work? and if so whats the availibility and cost of something like this?
1 - 4 of 4 Posts
flywheel
I do not think a rb26 flywheel would work. Rb26 flywheel is bigger(I think) and the qr25 uses a dual mass flywheel. The dual mass flywheel is the problem I hope nismo makes one
I do not think a rb26 flywheel would work. Rb26 flywheel is bigger(I think) and the qr25 uses a dual mass flywheel. The dual mass flywheel is the problem I hope nismo makes one
G
Guest
·do you think it would be possible/worth it to take it to a shop to get lightened?
flywheel
dual mass flywheels are hard to do. Which means the shop better know what its doing or you will have problems. I would wait for nismo or Jim wolf technologys to make one
dual mass flywheels are hard to do. Which means the shop better know what its doing or you will have problems. I would wait for nismo or Jim wolf technologys to make one
1 - 4 of 4 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Nissan Forum
Nissan Forums is the go to place to talk about your favorite Nissan model, including the Rogue, Maxima, Altima and even sports cars like the 370Z and 200SX.
Full Forum Listing
Recommended Communities
Join now to ask and comment!
