Nissan Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
just finished changing cylinder head, timing set at 10 degrees. starts and runs nicely. vacuum only 13 inches at idle and 2500. changed cat.
when I drive it loses power at about 4000 or so rpm.
any ideas as to what could be wrong would be greatly appreciated.
thanks, Mike
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top