Nissan Forum banner

1 - 2 of 2 Posts

·
ex-Super *********
Joined
·
1,410 Posts
Discussion Starter #1
Another little part I found for putting a water temp sender in your GA. Just cut a section of hose out and intstall this in place. Your gauge sender will screw right in. Does anyone know about/have one of these. I am wondering what size sender it is for and what size to get for GA water hoses. It seems like a cool little part, but I cant find any specs on it. If anyone knows let me/the rest of us know. It is a Greddy part and it lists for $28. Here are the part numbers(Greddy) and sizes

Part # - hose i.d.

16401630 - 30mm
16401634 - 34mm
16401636 - 36mm
16401638 - 38mm



 

·
Registered
Joined
·
156 Posts
Cutting into pressurized hoses = bad mojo

Pat,

I'm very leery of cutting into any pressurized hose (cooling system or otherwise). Everybody I have known who has ever done that (including me) for any reason (like installing a backflush tee or whatever) has eventually paid for it (within 10K) with a premature failure in the hose. My experience has been that you cut 'em anyplace except to trim the end, where it fits over a nipple with a clamp, it will blow long before its time.
 
1 - 2 of 2 Posts
Top