Nissan Forum banner
1 - 4 of 4 Posts

· Registered
330 Posts
Discussion Starter · #4 ·
I am building a flange for my custom header. (would like to have one like the HS (one that conects all pipes)) but the dipstick is crosing my planes. So I would like to remove the dipstick just temporary during header install.
Or can I just bent it so that the flange(later complete header) will slip in between the dipstick and the screews that come out of the head?

I am looking for a easy way of removing it, not a saw or a hammer . If it's not possible I will use two flanges.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.