Nissan Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
1,055 Posts
Discussion Starter · #1 ·
So far I have hooked up all my wires for my MTX 8000series, to my 3 10inch MTX 4000 subs at 4ohms.
But where would I put the RCA cords into my Kenwood Excelon CD-Deck?

In the Front? Rear? or Non-Fading?
I have tried mixing and matching, and no luck.... where to they go?
 

·
Registered
Joined
·
58 Posts
What amp is it you have? The 81000d?

I vote for non-fading as well, unless you aren't using the rear outputs for anything and you can use the front to rear fader as a bass control (some decks have a seperate level control for the non-fading). Basically non-fading lets you fade from front to rear and it doesn't affect the signal on the non-fading outputs. Sometimes called subwoofer output as well.

Juan
 
G

·
Yeah, scraping paint is a sad time... but it's ok... it could be worse - you could be drilling holes... :X.

Or you could get lucky and find a screw that is metal on metal... ;)
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top