Nissan Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
828 Posts
Discussion Starter #1
I have two codes p0335 Crank Shaft Position Sensor and p0725 Engine Speed Signal Circuit on a 2003 Altima 2.5 I'm going to replace the sensor. Anyone every done and it? Any unexpected issues I should be aware of. I'm familiar with the p0335 but not the second conde at insight on this?


Frank
 

·
Nissan Technician
Joined
·
826 Posts
Your 2nd code is associated with the 1st code. These 2 ALWAYS go hand in hand!!!

When you replace the crank sensor, be sure to look inside of the connector and make sure there isn't any engine oil in it. If there is, clean it out real good with some brake cleaner...:)
 

·
Registered
Joined
·
828 Posts
Discussion Starter #3
Where is it located? I have a 96 Altima and I can see it near the bell housing in front, but on the 2003 Altima, I looked and looked and did not see it. Any chance you can help me out with this? A picture or illustration?


Frank
 

·
Registered
Joined
·
828 Posts
Discussion Starter #4
So I replaced the sensor, but now the connector will not stay on the sensor. Has anyone experienced this issue? Any solutions?
 
1 - 5 of 5 Posts
Top