Nissan Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
This may be a stupid question but I'm asking it anyway. Is a crank pulley for an Sr20 compatible with the crank shaft for a ga16?
 

·
Registered
Joined
·
485 Posts
From everything I have found out on the situation... NO
But that has not been 100% confirmed.
 

·
DNE's VZR Conversion
Joined
·
6,079 Posts
no it will not work. they use different pulley sizes and different belts and timing marks.
 

·
Registered
Joined
·
24 Posts
Discussion Starter #4
The reason I ask is because I found an aluminum crank pully available from OBX for $70 and it's only available for the sr20de engine. I'd rather not spend 200 bux for and unothodox pulley.
 

·
DNE's VZR Conversion
Joined
·
6,079 Posts
The reason I ask is because I found an aluminum crank pully available from OBX for $70 and it's only available for the sr20de engine. I'd rather not spend 200 bux for and unothodox pulley.
i wouldnt trust obx pulley.

it not dyno proven and obx is.

i known for a fact that OBX quality isnt always top notch
 

·
Registered
Joined
·
24 Posts
Discussion Starter #6
so pretty much what you're saying is go big and not cheap? I'm just trying to find cost effective ways to give my sentra a little more power. Heard anygood things about OBX Headers? Thanks, Kevin
 
1 - 6 of 6 Posts
Top