Nissan Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
52 Posts
Discussion Starter #1
i removed my coolant and oil lines to the turbo to remove it. when i reattached the coolant line, the 19 mm bolt, back to the block it wont stop leaking. the washers i put on the bolt arent the same that were on it originally. i was told to use copper washers in both sides of the banjo fitting. Is that correct is there any type of sealant i should use to stop the leak.
 

·
KA24DET
Joined
·
1,000 Posts
shostopper82 said:
i removed my coolant and oil lines to the turbo to remove it. when i reattached the coolant line, the 19 mm bolt, back to the block it wont stop leaking. the washers i put on the bolt arent the same that were on it originally. i was told to use copper washers in both sides of the banjo fitting. Is that correct is there any type of sealant i should use to stop the leak.
Did you align the banjo bolt correctly?
 
1 - 2 of 2 Posts
Top