Nissan Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
119 Posts
Discussion Starter #1
I've been trying to find an easy way to fix a worn out hole for the compression rod. i'm thinking about welding a washer in that is slightly bigger than the rod's sleeve. does this sound ok?

thanks
 

·
Registered
Joined
·
119 Posts
Discussion Starter #3
well, the pass side is was kinda sloppy, and like i said, if this is my problem it's gonna be the driver side. so i suspect that it's gonna be nasty. i didn't think there was enough room for a grinder...maybe i'll go that avenue.

thanks
 
1 - 5 of 5 Posts
Top