Nissan Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2,716 Posts
The P0014 can be caused by the following:
  • Bad crankshaft position sensor
  • Bad camshaft position sensor
  • Bad exhaust valve timing control position sensor
  • Bad exhaust valve control solenoid valve
  • Accumulation of debris to the signal pick-up portion of the camshaft
  • Foreign matter caught in the oil groove for exhaust valve timing control
This post has to be in the wrong forum. P0014 is EVT and not IVT. It's only valid for gen2 Rogues, not gen1's of any MY.
 

·
Registered
Joined
·
2,716 Posts
In that case, the P0014 is a "performance" code for the exhaust cam. Although Nissan lists the exhaust cam sensor and crank sensor as primary suspects, that's rarely the case. It's more likely a stuck EVT solenoid or a hydraulic problem (low engine oil, wrong viscosity, or gunk in the timing cover oil passages). Of 201 confirmed fixes in Identifix's database, 179 were repaired by a new EVT Solenoid.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top