Nissan Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Did your clutch probs just start or are you finishing a repair? Can you extract the rest of the bleed valve from the slave cylinder? It's possible but not too likely that the actuator rod is bent or broken. Is the slave cylinder leaking? Did you install a rebuild kit? If you can extract the threaded portion of the bleed valve and the slave cylinder wasn't leaking, I would replace the bleed valve and try bleeding it again. I'm one of those guys with more time than money right now.:)
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top