Nissan Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hello all I've been visiting the site for months now before I bought my own Z32, its an awsome site. Well I finally bought a 90 NA 5 speed that needs a little work, i just completed a brake job and also replaced the clutch slave and bleed the system from both bleeds, now it wont even go in gear. It was having problems going in gear before I replaced the clutch slave and bleed the system. Any ideas out there?
 

·
Power FC Z32
Joined
·
2,147 Posts
Hello all I've been visiting the site for months now before I bought my own Z32, its an awsome site. Well I finally bought a 90 NA 5 speed that needs a little work, i just completed a brake job and also replaced the clutch slave and bleed the system from both bleeds, now it wont even go in gear. It was having problems going in gear before I replaced the clutch slave and bleed the system. Any ideas out there?
There is a additional bleed located near the power steering reservoir.

http://300zx-twinturbo.com/cgi-bin/manual.cgi?list=cl&dir=&config=&refresh=&direction=forward&scale=0&cycle=off&slide=8&design=default&total=18


Which clutch did you replace it with?
 
1 - 3 of 3 Posts
Top