Nissan Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 · (Edited)
Good day fellow Nissan owners! I just got my OBD1 scanner and I want to know how to tune my own car which is a B13 4 door with a GA16DE engine, does anybody know how to interpret the all of the data shown on the scanner? like for example: how would I match the signal of the TPS to the rest of the sensors? Do they have a chart with acceptable ranges of values? How to distinguish a bad reading from the good? because the book 1 of the service manual shows resistance values only. Can I use resistance values on the book 1 as a guide or template when adjusting the sensors through the scanner? thank you so much guys I hope someone could help me. Stay safe!

P.S. I was advised that sensor calibration is way more complicated and to not rely on resistance or voltage when tuning.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top