Nissan Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
204 Posts
Discussion Starter #1
I have a 1990 nx1600 (well, its registerd as a 1990, but i guess its a 91)
digital dash.... can i remove the seatbelt wires, on the clip, and on the actual belt bracket?
also, mine is manual, and in the center console between the seats, there is a plug with three (i think) wires going into it, can i remove this also?
thanks
Cory
 

·
Registered
Joined
·
204 Posts
Discussion Starter #2
on doing a little bit of research, i have found that it is the B35 connector, and is for the console harness. But i dont have anything in my car for it to hook up to, so it should be ok to remove this??
just want to make sure that its not going to stop my car from going when i get around to getting it going again.
 

·
Your electrical friend
Joined
·
2,177 Posts
Removing it won't change anything, so I'd say leave it alone.
 

·
Registered
Joined
·
204 Posts
Discussion Starter #4
well, im looking at removing the whole center console thing, and having that plug dangling out of there is a bit of an eye sore. and as for the seat belt wires, they are just plain annoying if i dont have a seat belt warning light.
 
1 - 4 of 4 Posts
Top